Friday, December 30, 2011

Setting the Serial Port of a OSEPP Uno On Mac OS X Lion

I am new to Arduino hacking and as such I installed the latest Arduino software that comes without the need to install separate USB drivers, ie. the FTDIUSBSerialDriver_10_4_10_5_10_6.mpkg file with older Arduino software installs for Mac.

I am on Mac OS X 10.7 (Lion) as well.

So, when I hooked up a second Arduino board I bought yesterday, an OSEPP Uno Rev 1.1, I could not load sketches onto it.

I went to the getting started website for the OSEPP Uno, which suggested setting the board to an “Arduino Duemilanove or Nano w/ ATmega328″ to get it to work. Still nothing.

I looked at the Serial Ports but there were no usbserial ports listed. So, start debugging. I opened the Console and tried unplugging/plugging in the board, sure enough there was an error:

kernel: 0 0 AppleUSBCDC: start - initDevice failed


So, rereading the getting started site, I released that since this board was a little older I might just need to the older drivers.

I downloaded the Arduino 0023 drivers from the Arduino Software page for Mac OS X. I installed just the FTDIUSBSerialDriver_10_4_10_5_10_6.mpkg file.

Restart the Arduino IDE and voila, there should not be a /dev/tty.usbserial-* device that will be the OSEPP Uno board. You can then load your programs.

Hope that helps.

3 comments:

B1g0nE said...

Thank Youvery much. You just rescued my afternoon. Nerd high-five!
-Alan

Unknown said...

This is a link to the latest FTDI VCP drivers for all operating systems.
http://www.ftdichip.com/Drivers/VCP.htm

VCP = Virtual Com Port

Installing the appropriate driver and selecting the board as UNO in the latest Arduino release solved my problems in OS X Lion.

BJ MacNevin said...

Sam! Thanks! Mine works now. Didn't find the Uno thing on my own. Duh! :)